|• Care for Pavers|
|• Cavity Wall Moisture Management|
|• Cleaning and Removing Stains Outdoor On Outdoor Pavers|
|• Mortar & Restoration|
|• Protecting Pavers From Stains|
|• Stone Veneer|
|Learn More About Sponsored Topics|
The Official Publication
of the Mason Contractors
Association of America
Rehab/Restoration Case Studies
Restoring a Fountain of Leadership
Hoffman Cortes Contracting Co. Foreman Doug Norbury led the charge to restore Kansas City, Mo.’s, oldest working fountain, the Women’s Leadership Fountain.
Kessler and Van Brunt decided on a simple, oval design with a limestone basin and nozzles in the center of the basin’s pool, where water shoots up in the air. The fountain was surrounded by a raised sidewalk, floor garden, gas lamps and a balustrade that cost $4,115 to construct.
In the 1940s, the fountain stopped working, but it was repaired in 1970 and, again, in 1990. The renovation in the 1990s was possible through the Central Exchange, which led efforts to raise the $125,000 needed to properly restore the fountain. For the Central Exchange’s efforts, the fountain was renamed the “Women’s Leadership Fountain,” and the names of the 12 women who made the restoration possible were inscribed on it.
Unfortunately, this restoration did not hold. In January 2008, restoration of the fountain began again. The Central Exchange came together with Kansas City Parks and Recreation, Ollie Gates and several other prominent Kansas City residents to raise $1.3 million for a complete renovation that included the foundation, its plumbing, and Meyer and Fitz-Simmons monuments, located nearby. Vannom Construction was hired as the general contractor and quickly brought in Hoffman Cortes Contracting Co. and Susan Richards Johnson & Associates Inc. (architects), to revive the historic fountain.
Limestone not only is expensive, but also is difficult to find. Not to mention, the decorative elements included in the fountain were difficult to duplicate.
Chuck Scammell with Hoffman Cortes recalled using Indiana limestone on a previous project and knew exactly what to do. First, he contacted Sturgis Materials to locate a quarry that produced this type of limestone, matching the remaining pieces of the fountain. Next, Hoffman Cortes and Susan Richards Johnson found a fabricator that could produce finny holes – or decorative pieces – almost identical to the original ones.
The project team was creative during the installation, because they wanted the fountain to look as seamless as possible. They demolished select pieces of the fountain, and then incorporated the salvaged pieces back into the fountain. Once this was finished, they replaced the baluster system, and the fountain was once again running.
|Last Updated on Tuesday, 12 April 2011 14:54|