RSS
TwitterFacebookGoogle+YouTubeLinkedIn

Featured Product: Abort Gate for Dust Collection Equipment

Facebooktwittergoogle_plusredditpinterestlinkedinmail

Abort Gate for Dust Collection Equipment

Jackson Center, Pa.

Imperial Systems, Inc. Abort Gates are an important part of any duct spark or leak detection system.
 
Proper Uses for a High Speed Abort Gate:
• An abort gate can be located prior to the inlet of a dust collection system to prevent a flame or burning ember from entering the dust collection system. This method is used if extinguishment from your spark detection equipment is not adequate or not an option.
• Leak detection or broken bag sensors can activate the abort gate in the event of a filter failure. The abort gate can be placed on the return air side of the dust collector to redirect contaminated air to safe location.
 
An abort gate is just another way to keep personnel and dust collection equipment protected.
 
The Standard Features include: heavy-duty fully welded steel construction, painted OSHA safety yellow, 110 volt control panel, manual gate reset by a hand-crank actuator, gate accelerating springs, fail-safe electro-magnets, steel gate seals and limit switches for gate position indication.  Electric gate reset, weather hood, inlet and outlet transitions, support structure and ladder and service platform are all available optional features.
 
Imperial Systems, Inc. abort gates are 100% compatible with all brands of fire & explosion suppression equipment!  All units are factory tested prior to shipment.

www.isystemsweb.com

MASONRY MAGAZINE VIDEO NEWS

S26 HEPA Dust Extractor From Pullman Ermator

Ermator HEPA Dust Extractors are equipped with tested and certified HEPA filters that trap the smallest, most dangerous-to-breath dust particles and prevents them from being released in the air. A HEPA Dust Extractor not only exhausts perfectly clean air, it is far more efficient for the fast recovery of bulk dry dust, debris and other building materials found on every Construction, Abatement and Restoration job site.

Drilling and Chiseling Hammer Demonstration | CS Unitec

CS Unitec Drilling and Chiseling Hammer type 2 2414 0010 demonstration. For more information on the tools, drills and other products seen in this video, please visit: http://www.csunitec.com/hammer-drills/

PumpMaster | Masonry Grout Pump for Core Filling | Block Fill | Masonry Wall Grouting

The AIRPLACO PumpMaster PG-30 is shown on a jobsite in Nashville, TN with Masonry Contractor WASCO, Inc. ...