Home Page of Masonry Magazine

Advertise to mason contractors

Subscribe to Masonry Magazine
Sponsors of Masonry Magazine
Classified Advertising for Mason Contractors
Contact Masonry Magazine
Search Masonry Magazine
Order reprints of Masonry Magazine
News for masonry contractors
Calendar of masonry events
Links to masonry related sites
Web site of the Mason Contractors Association of America
Web site of the Mason Contractors Association of America
Sponsored topics:
Mortar & Restoration NEW!
Masonry Magazine Readership Survey

November 2007

Green Building


Masonry MagazineSide Story:
Heating Green

Masonry heaters are firing up green building practices. A masonry heater is a unique type of masonry fireplace that is able to burn wood cleanly. By rapidly burning a large batch of wood (up to 60 pounds), the heater stores the heat in a masonry thermal mass. The masonry then radiates heat gently into the building for up to 24 hours or more from a single two-hour firing.

Several aspects of masonry heaters tie in directly to green building, including greenhouse gas reduction, low output capacity and radiant heat:

• Greenhouse gas reduction
Wood is a renewable fuel, particularly if harvested as part of a sustainable forestry operation. The downside of burning wood is air pollution. Wood is potentially a clean fuel. Pollution from wood burning is almost entirely the result of incomplete (smoldering) combustion. It can be greatly reduced by improved burn methods, and masonry heaters achieve this by burning the wood rapidly in a hot fire and then using the masonry mass to store the heat. Chimney flues have been known to stay clean for 20 years and longer with proper operator practice.

• Low output capability
In a large, 8,000-pound heater, the heat from a two-hour burn of 60 pounds of wood can be radiated into the building over a span of 24 hours, at roughly 10,000 BTUs per hour. In many locations, this is a typical heat load for a superinsulated building on an average day. Other cordwood burning appliances have difficulty targeting such low heat loads without resorting to smoldering (dirty) combustion.

• Radiant heat
A typical large heater will have about 100 square feet of radiating masonry surface at about 150 degrees farenheit. This is widely regarded as a comfortable and healthy type of heating, similar to what is obtainable with a hydronic floor. There is minimal air movement, and a reduction in dust circulation.






 
 

www.masonrymagazine.com

MASONRY
©2007 by the Mason Contractors Association of America
All rights reserved
33 South Roselle Road, Schaumburg, IL 60193
Phone: 847-301-0001 or 800-536-2225 | Fax: 847-301-1110

Web site by: Lionheart Publishing, Inc.
506 Roswell Street, Suite 220, Marietta, GA 30060
Phone: 770-431-0867 | Fax: 770-432-6969
lpi@lionhrtpub.com
www.lionhrtpub.com